Using the Main Menu13
1. From the Live View screen, click > Setup > System > General > Output
Configuration.
2. Click-and-drag the slider next to Transparency to adjust the transparency of the Taskbar
and menu screens.
3. Click Save.
13.2.8 Configuring Basic Network Settings
The basic network menu allows you to change port numbers if needed and configure the network
protocol type (DHCP or static).
To configure basic network settings:
1. From the Live View screen, click
> Setup > Network > Network Setup.
2. DHCP is enabled by default (recommended).
NOTE
Disabling DHCP requires you to edit the IP Address, Subnet Mask, Gateway and DNS settings. This option
is for advanced users only.
3. Click the fields next to Client Port and HTTP Port to change port numbers if required.
4. When DHCP is disabled: Click the fields next to IP Address, Subnet Mask, Gateway and
DNS to edit as required.
5. Click Save.
#LX400115; r. 4.0/58631/58631; en-US 45
To Next Page
Loading...
Need help?
General
