Chapter 8 EMC Standard Certification
Directive:
Electromagnetic Compatibility Directive 89/336/EEC amended by the Directive 93/68/EEC
8.1.2
KC Standard Certification
The XGT Panel acquire the electromagnetic fitness registration (KC specification) certified by wave laboratory
under information-communication part.
A grade device
This device acquires KC for industrial use.
If device is not purchased properly, exchange it to device for home use.
8.2
Requirement for Low Voltage Command Suitability
It is required to get the needed Stability for the device operated at AC50~1000V, DC75~1500V’s power. The following
describes attention about installation and wiring for the suitability when using the XGT Panel. Though the following
data is made by requirement of regulation and standard, we don’t guarantee that all devices are suitable for the above
command. The method to be suitable for the EMC command and judgment of suitability should be finally made by
device manufacturer himself.
8.2.1
Standard Certification for XGT Panel
XGT Panel is according to the EN61131-2:2007 (stability of device used in the measure, control laboratory).
8.2.2
Selection of XGT Panel
(1) iXP2-0800A, iXP2-1000A, iXP2-1200A, iXP2-1500A
Power module with rated input voltage of AC100 / 240V has hazardous voltage (voltage of 42.4V peak or more) inside.
Therefore, the CE marked product is reinforced and insulated between the internal primary and secondary
(2) iXP2-0800D, iXP2-1000D, iXP2-1200D, iXP2-1500D
I/O modules with a DC 24V rating or less are out of the low voltage command target range.
To Next Page
Loading...
Need help?
General