Lutron Electronics RadioRA - Page 18

RadioRA® Setup Guide1-15
Setting Light Levels/GRAFIK Eye® Scene Selection for
SCENE Buttons
Note: Dimmers can be set to a variable light level or turned OFF. Switches can be turned ON or OFF. GRAFIK
Eye® Control Units can be set to any scene or turned OFF.
Step 1 Begin setting light levels/
GRAFIK Eye® scene selection
Step 3 Set light levels/select GRAFIK
Eye® scenes
SCENE Button Programming
Simultaneously press the 1st and 5th buttons
in the right most column until the upper right
LED begins to blink (approximately 3
seconds).
Step 2 Select a SCENE button
Press and release the SCENE button that you want to
program. Its LED will begin to blink.
Go to any assigned Dimmer (which will be
ON at 50%). Adjust this Dimmers programmed
light level for the selected SCENE button
using the dimming rocker, or turn the Dimmer
OFF if it is to be turned OFF when this SCENE
button is pressed.
Adjust light levels
Turn OFF
OR
LUTRON
Go to any assigned GRAFIK Eye® Control
Unit (which will be ON at scene 1). Select from
pre-programmed scenes (1 through 4) by
turning that scene ON or select OFF if it is to
be turned OFF when this SCENE button is
pressed.
Go to any assigned Switch (which will be
ON). Turn the Switch OFF if it is to be turned
OFF when this SCENE button is pressed.
All devices assigned to that button will turn ON
to: Dimmers 50% light level, Switches ON, and
GRAFIK Eye® Control Units to scene 1. All
devices not assigned to that button will turn
OFF.
Upper right LED blinks.
ALL ON
ALL OFF
Tabletop Master Wall Master
OR
Section 1 - Start-Up