LXNAV S100 - Auto Finish; Finish before off; Logger Always on; Pilot

Rev #37 Version 8.0 April 2021
Page 45 of 121
5.7.2.2 Auto Finish
If this functionality is enabled, the flight recorder will automatically finish the flight under the
following conditions:
• GPS status OK
• Groundspeed lower than 20 km/h
• True airspeed lower than 40km/h
• Absolute vario lower than 1m/s for 300 seconds
5.7.2.3 Finish Before OFF
If this setting is enabled the flight will be finished if the user powers down the unit.
5.7.2.4 Logger Always ON
This setting will enable logging of flight immediately after power on and will log the fight
until the unit is powered down. The only condition to start logging is the presence of a valid
time (GPS status BAD or OK). Logging will not start if the GPS status is Very Bad (no valid
time present).
5.7.2.5 Pilot
Insert the pilot’s name which will be stored in the declaration.
5.7.2.6 Co-Pilot
If the system is used in a two-seater the name of the co-pilot may also be entered.
5.7.2.7 Competition Number
Insert the competition number of the glider which is also stored in the flight file.
5.7.2.8 Registration Number
Insert the registration number of the glider which is also stored in the flight file.