Lynx NGT-9000
Installation Manual
3.9.2 Live Data - GPS
1. From the Lynx MAT select ServiceZLive DataZGPS. An example of this page is shown in Figure
3-16.
2. Observe that the GPS data is being received.
3. If data is being received verify that the Day, Month, and Year data is correct.
• Observe that the GPS data is being received and signal strength is within 30 to 50 db. Note – the
Navigation State always shows “RAIM” even though the device is actually in WAAS mode.
4. If data is not being received do the following:
• The GPS signal may be blocked; move the aircraft to an open environment or input a GPS
signal using test equipment.
• Check the fault log (InfoZFault Log) for issues.
• Check wiring or GPS antenna for installation issues.
Figure 3-16: Lynx MAT – Live Data - GPS
Page 3-20 Installation Checkout 0040-17001-01
January 15, 2015 Revision A
To Next Page
Loading...
