77
When set to Program Cycle, these are the available parameters:
Values: The Encoder will cycle through this many Program values (one at a time) when you
turn it: 1 Values, 2 Values, 3 Values, or 4 Values.
Available Values:
• 2 Values
• 3 Values
• 4 Values
First: The Encoder will send this Program message first when you press it.
Available Values: 0-127
Second: The Encoder will send this Program message second when you press it.
Available Values: 0-127
Third: The Encoder will send this Program message third when you press it.
Available Values: 0-127
Last: The Encoder will send this Program message last when you press it.
Available Values: 0-127
When set to Program IN/DC (PG IN/DC), these are the available parameters:
Type: The Encoder will send the next (Increment) or previous (Decrement) value number in
the range of values when you turn it.
Minimum: The lowest Program value in the range of values will correspond with this setting.
Available Values: 0-127
Maximum: The highest Program value in the range of values will correspond with this setting.
Available Values: 0-127
When set to CC Cycle, these are the available parameters:
CC: The Encoder will send its MIDI messages using this CC number.
Available Values: 0-127
Values: The Encoder will send the value with this CC number when you turn it, one at a time,
cycling through them with each notch.
Available Values:
• 2 Values
• 3 Values
• 4 Values
First: The Encoder will send the MIDI CC number with this value when you first turn it.
Available Values: 0-127
To Next Page
Loading...
Need help?
General
