Magicard PRIMA401 - Counter Setting; Display Mode Setting

Display Mode Setting
v
This is used for setting the information to be displayed on the
operation panel.
Settings
v
Counter:
Displays the counter preset in "Counter setting".
v
Laminator State:
Displays the operating status of the connected laminator. If a
laminator is not connected, the counter is displayed.
1
Press I
v
A [Cleaning] message appears.
.
2
Press J to set to [Setting]
v
Pressing it each time displays the next setting item.
.
3
Press G
v
A [Display] message appears.
.
4
Press G
v
A [Mode] message appears.
.
5
Press F
v
Enters the settings change mode.
.
6
Press A and select a setting
7
Press B to confirm the setting
v
Pressing B confirms the setting and returns you to the previous
screen.
8
Press H to exit the setting mode
v
Pressing it each time displays the setting item on the next higher level.
Counter Setting
v
This is used for setting the type of counter displayed on the
operation panel.
Counter Types
v
Total Cnt: total counter
Displays the total number of cards that are correctly printed.
v
Head Cnt: head counter
Displays the total number of printed sides for the same head.
v
Free Cnt: free counter
Displays the number of cards that are correctly printed. This number
can be reset.
v
Cleaning Cnt: cleaning counter
Displays the number of cards that are correctly printed after the last
cleaning.
v
Error Cnt: error counter
Displays the number of cards that are not correctly printed. This
number can be reset.
1
Press I
v
A [Cleaning] message appears.
.
2
Press J to set to [Setting]
v
Pressing it each time displays the next setting item.
.
3
Press G
v
A [Display] message appears.
.
4
Press G
v
A [Mode] message appears.
.
5
Press J to set to [Counter]
.
Operating the Printer
25