Mahindra 2816 HST User Manual

16 Series, Model - 2816 HST
Front Axle Oil Level
To check the front axle oil level, put
the tractor on level ground. Remove
the oil level plugs located on the
rear of the both gear cases. If the oil
level is low, add the recommended
oil type through the fill hole located
on the RH side of axle housing until
the oil begins to flow out of the level
plug holes.
FRONT AXLE LUBRICATION (MFD)
Service Specifications
Oil Change Interval ..................................... Every 200 hours (See NOTE)
Oil Capacity ..............................................................4.0 Litres (4.2 Quarts)
Oil Type ....................................................... SAE 85W-140 Gear Lubricant
NOTE: Change the oil after the first 50 hours of operation and then
every 200 hours of operation.
OIL LEVEL
PLUG
DRAIN PLUG
LEVEL
PLUG
LEVEL
PLUG
GREASE NIPPLE
FILL CAP
114
LUBRICATION/FILTERS/FLUIDS _____________________________________________

Mahindra 2816 HST Specifications

General

Brand	Mahindra
Model	2816 HST
Category	Lawn Mower
Language	English