16 Series, Model - 2816 HST
36
NOTE:
1. The Rear and Mid PTO shaft can be operated at the same time.
2. When not using the Mid PTO shaft, cover the shaft with the Mid PTO
cover.
a
2. REAR PTO CONTROL LEVER – Move the lever forward to engage
the REAR PTO. Move the
lever rearward to disen-
gage the Rear PTO.
NOTE: Be sure the Rear
PTO control lever is in OFF
slot when starting the
engine
1. RANGE SHIFT LEVER — Move the range shift lever forward to place
the transmission in L range.
Move the lever to the rear-
ward to place the trans-
mission in M or H range.
The center position be-
tween M and L or H and M
places the transmission in
N.
NOTE: Be sure the range
shift lever is In N (Engine
start) slot when starting the
engine.
3. MID PTO CONTROL LEVER (IF EQUIPPED) — Move the lever
forward to engage the MID
PTO. Move the lever rear-
ward to disengage the Mid
PTO.
NOTE: Be sure the Mid
PTO control lever is in OFF
slot when starting the
engine.
INSTRUMENTS/CONTROLS _____________________________________________
To Next Page
Loading...
