16 Series, Model - 2816 HST
28
OPERATING CONTROLS
Control Switches
position–
(OFF)
position–
(HEAT)
&
(ON)
position –
(START)
Turn the key fully clockwise against the force of the
spring in the switch. The starter motor will turn the
engine. Release the key immediately when engine
starts.
NOTE: To prevent operation by persons not authorized and the
possible discharge of the battery, remove the starter key when you leave
the tractor.
IMPORTANT: Do not keep the starter key switch in the ON position for
a long period of time when the engine is not operating.
1. STARTER KEY SWITCH — The starter key switch can be removed
with the switch in the OFF position. Four
position switch as follows:
Engine and all lamps except the
turn signal and flasher lamps are
turned off.
First position clockwise from
OFF. In this position (Engine not
running) energizes the glow
plugs. The charge indicator, glow
plug indicator and oil pressure in-
dicator will illuminate.
The fuel gauge and temperature gauge will show correct values.
INSTRUMENTS/CONTROLS _____________________________________________
To Next Page
Loading...
Need help?
General
