16 Series, Model - 2816 HST
52
HYDROSTATIC DRIVE TRANSMISSION
The Hydrostatic drive transmission has a forward/reverse hydrostatic sec-
tion and a three-speed range section. This arrangement gives three
forward and three reverse speeds range.
Transmission Operation
1. Push the clutch pedal fully and stop the tractor. Move the range shift
lever to the position needed, H, M or L.
2. Release the clutch pedal slowly.
3. Operate the speed ratio control pedal to move the tractor.
To shift from reverse to forward or from forward to reverse, move the
speed ratio control pedal without disengaging the clutch.
SPEED RATIO
CONTROL PEDAL ( FORWARD )
SPEED RATIO
CONTROL PEDAL (REVERSE)
RANGE SHIFT LEVER
IMPORTANT: Before selecting a new range, stop the tractor and push
the clutch pedal. Do not change range when the tractor is moving.
Travel speed should be such that complete control and machine sta-
bility is maintained at all times. Where possible, avoid operating near
ditches, embankments and holes. Reduce speed when turning,
crossing slopes, and on rough, slick, or muddy surfaces.
M109A
OPERATING INSTRUCTIONS _______________________________________________
To Next Page
Loading...
Need help?
General
