Mahindra 2816 HST User Manual

16 Series, Model - 2816 HST
57
MID PTO
LEVER
CLUTCH PEDAL
MID PTO SHAFT
The following table shows the required engine speed to get the required
Mid PTO output shaft speed.
Mid PTO
The Mid PTO has a 25.4 mm (1
inch) diameter 15 spline output
shaft.
ENGAGE THE MID PTO AS
FOLLOWS:
1. Push the clutch pedal fully.
2. Move the Mid PTO control
lever forward.
3. Release the clutch pedal slow-
ly.
DISENGAGE THE MID PTO AS
FOLLOWS:
1. Push the clutch pedal fully.
2. Move the Mid PTO control
lever to the OFF (Engine Start)
slot.
MID PTO Output
Shaft Speed
Required
Engine Speed
2000 RPM
2632 RPM
NOTE: Keep the Mid PTO
control lever in the OFF (Engine
Start) slot when starting the en-
gine and when the PTO is not being used.
3. Release the clutch pedal.
OPERATING INSTRUCTIONS _______________________________________________

Mahindra 2816 HST Specifications

General

Brand	Mahindra
Model	2816 HST
Category	Lawn Mower
Language	English