16 Series, Model - 2816 HST
46
Turn key switch to start position
until engine starts, but no more
than 10 seconds, then release
the key. Run engine for two
minutes at 1500 RPM.
STEP 8
When the engine starts, check
the oil pressure indicator and
charge indicator.
If the indicators stay on, stop
the engine and find out what is
wrong.
Push the clutch pedal down.
STEP 6
CLUTCH PEDAL
STEP 7
START
NOTE: If the oil pressure indicator stays on after the engine starts, stop
the engine and check the oil level in the crankcase. Add oil if necessary.
Start the engine, if the indicator is still on, do not operate the engine.
Operating the engine without oil pressure will damage engine bearings
and other engine parts. See your dealer.
IMPORTANT:
1. If high idle position is used for starting, adjust the engine speed
control lever to obtain about 1500 RPM as soon as the engine starts.
2. If the engine starts and then stops, wait for the starting motor to stop
turning before you turn the key switch to START position again.
OPERATING INSTRUCTIONS _______________________________________________
To Next Page
Loading...
Need help?
General
