OPERATING PROCEDURES GRT9165 OPERATOR MANUAL
4-54 Published 7-23-2020, Control # 668-02
11. Press the Engine Button on the Remote Control Unit.
The Engine Screen appears in the display.
The operator must start the engine from the Remote
Control Unit. Refer to Engine Start/Stop/Throttle, page
4-57.
Once the engine is started, the operator can operate the
crane functions from the Remote Control Unit.
The Remote Control Unit remains ON until one of the
following occurs:
• Operator presses the Power Button on the Remote
Control Unit
• Battery power is too low
12. Set the Remote Control to OFF by doing the following:
a. If desired, stop the engine with the Remote Control
Unit. See Engine Start/Stop/Throttle, page 4-57.
b. Set the Remote Control Unit to OFF by pressing the
Power Button on the Remote Control Unit.
c. Disable the Remote Control Unit by pressing the
bottom of the Remote Control Enable/Disable
Switch in the cab.
To Next Page
Loading...
Need help?
General
