5-8 Published 7-23-2020, Control # 668-02
SET-UP AND INSTALLATION GRT9165 OPERATOR MANUAL
Access Ladders
The access ladders (1, Figure 5-7) are located on the front
and rear outrigger boxes. The access ladders must be raised
for transport and must be lowered during operation.
Raising the Access Ladder for Transport
1. Remove retaining clips (3) and pins (2).
2. Raise the ladder (1) in to transport position.
3. Install pins (2). Install retaining clips (3) to secure the
pins.
Lowering the Access Ladder
1. Remove retaining clips (3) and pins (2).
2. Lower the ladder (1).
3. Install pins (2). Install retaining clips (3) to secure the
pins.
Auxiliary Ladder
Figure 5-8 shows the stowage and possible installation
locations for the auxiliary ladder when the outrigger boxes
are removed. The auxiliary ladder is stowed under the
hydraulic tank on the lower right side of the carrier. The
auxiliary ladder must be stowed for transport.
1
3
2
Working Position
FIGURE 5-7
3
2
Transport Position
9942
9943
9944