Grove Published 7-23-2020, Control # 668-02 3-19
GRT9165 OPERATOR MANUAL OPERATING CONTROLS AND FEATURES
Turntable Swing Lock Pin Control Handle
The Turntable Swing Lock Pin Control Handle
(1, Figure 3-13) is located on the right lower control panel.
To lock superstructure in position, perform the following
steps:
1. Center superstructure over the front or rear of the
carrier.
2. Turn Swing Lock Pin Control Handle counterclockwise
to unlock it.
3. Push forward on the control handle to cause the swing
lock pin to drop into the socket on the carrier frame.
4. Turn control handle clockwise to lock it in position.
To unlock superstructure, perform the following steps:
1. Turn control handle counterclockwise to unlock it.
2. Pull rearward on the control handle to cause the swing
lock pin to pull out of the socket.
3. Turn control handle clockwise to lock it in position.
NOTE: Before driving crane, always make sure that the
boom is centered over the front or rear of the
carrier and that the turntable swing lock pin is
engaged.
12-Volt Outlet
The 12-Volt Outlet (2, Figure 3-13) is located on the right
lower control panel.
The 12-volt Outlet can power and charge electronic devices
that have a maximum current draw of 15 amps or less.
Engine On-Board Diagnostic (OBD)
Connector
The Engine On-Board Diagnostic (OBD) Connector
(3, Figure 3-13) is located on the right lower control panel.
The connector allows the Cummins service software tool to
be connected to the engine electronic control unit (ECU) for
diagnosing issues that may occur.
A second Engine OBD Connector is located in the battery
box.