Manitowoc Grove GRT9165

Grove Published 7-23-2020, Control # 668-02 3-9
GRT9165 OPERATOR MANUAL OPERATING CONTROLS AND FEATURES
3
Turn Ignition Switch to the RUN (I) position to energize all
electrical components except the starting circuit.
Turn Ignition Switch to the START (II) position to energize the
start circuit and crank the engine for starting. Release
ignition switch when the engine starts.
The Ignition Switch is spring-returned from START (II) to
RUN (I). Turn Ignition Switch to the OFF (0) position to stop
the engine.
The Ignition Switch has an anti-restart feature. After a failed
attempt to start the engine, the crane control system
prevents the engine from cranking again for approximately
six seconds.
Steering Column Tilt and Telescope Lock
Lever
The steering control column can be rotated rearward
approximately 30° and telescoped approximately 60 mm
(2.3 in).
Rotate the Lock Lever (9, Figure 3-2) clockwise to lock the
steering column in place. Rotate the lever counterclockwise
to release the steering column for adjustment.