SET-UP AND INSTALLATION MLC650 VPC-MAX™ OPERATOR MANUAL
4-110
Published 04-06-18, Control # 231-14
Disconnecting the First Insert and Mast Butt Straps
See Figure 4-91 for the following procedure.
1. Disconnect the strap from the links in the working
position.
2. Remove the hair pin cotters (1) from the VPC-MAX
beam strap (2) retaining pin (3).
3. Rotate the retaining pin brackets (4) from the working
position to the stored position.
4. Place the strap in the stored position.
5. Install the retaining pin and hair pin cotters to the
brackets in the stored position.
6. Remove the cotter pins (5) from the VPC-MAX beam
link (6) retaining pin (7).
7. Rotate the links to the stored position.
8. Remove the retaining pin from the working position and
install the pin in the stored position.
9. Install the cotter pins to the retaining pin.
10. Repeat this process for the other side of the mast butt
and insert.
FIGURE 4-91
STORED POSITION
WORKING POSITION
Item Description
1 Hair Pin Cotter (qty 4)
2
VPC-MAX
Beam Strap (qty 2)
3 Retaining Pin (qty 2)
4 Retaining Pin Bracket (qty 4)
5 Cotter Pin (qty 4)
6
VPC-MAX
Beam Link (qty 4)
7 Retaining Pin (qty 2)
To Next Page
Loading...
Need help?
General
