Manitowoc VPC-MAX MLC650 - Drawing the VPC-MAX Beam Onto the Rotating Bed

Manitowoc Published 04-06-18, Control # 231-14 4-31
MLC650 VPC-MAX™ OPERATOR MANUAL SET-UP AND INSTALLATION
4
Drawing the VPC-MAX Beam onto the Rotating Bed
See Figure 4-30 for the following procedure.
1. With the two rear pendants (1) still attached to the rear
lifting lugs on the VPC-MAX beam (2), slowly lift the end
of the beam off the blocking.
2. Continue to lift the beam to a horizontal position.
3. Turn on the cab power and the remote control key.
4. Using the remote control, drive the actuator (3) forward
to the minimum working position while following with the
assist crane.
5. While performing step 4
, verify that the beam in and out
switches are operating properly. See Section 6 of this
manual for detailed instructions.
FIGURE 4-30
Item Description
1 Pendant (qty 4)
2 VPC-MAX Beam
3 Actuator