Manitowoc VPC-MAX MLC650 - Removing the Large Main Stop Blocks

Manitowoc Published 04-06-18, Control # 231-14 4-15
MLC650 VPC-MAX™ OPERATOR MANUAL SET-UP AND INSTALLATION
4
Removing the Large Main Stop Blocks
See Figure 4-17 for the following procedure.
1. Remove the safety pins (1) from the large main stop
blocks (2) on the rear of the rotating bed.
2. Remove the large stop blocks.
NOTE: Do not remove the small bolt-on stop blocks (3).
FIGURE 4-17
Item Description
1 Safety Pin (qty 2)
2 Large Main Stop Block (qty 2)
3 Small Bolt-on Stop Block (qty 2)