SET-UP AND INSTALLATION MLC650 VPC-MAX™ OPERATOR MANUAL
4-140
Published 04-06-18, Control # 231-14
Removing the Actuator
Removing the Large Main Stop Blocks
See Figure 4-117 for the following procedure.
1. Remove the hair pin cotters (1) from the large main stop
blocks (2) on the rear of the rotating bed.
2. Remove the stop blocks.
NOTE: Do not remove the small bolt-on stop blocks (3).
FIGURE 4-117
Item Description
1 Hair Pin Cotter (qty 2)
2 Large Main Stop Block (qty 2)
3 Small Bolt-on Stop Block (qty 2)
To Next Page
Loading...
