Manitowoc Published 04-06-18, Control # 231-14 4-41
MLC650 VPC-MAX™ OPERATOR MANUAL SET-UP AND INSTALLATION
Calibrating the Counterweight Tray
See Figure 4-38 for the following procedure.
1. Using the remote control, drive the counterweight tray
(1, View A) all the way forward to the stop blocks (3) on
the actuator.
2. Calibrate the counterweight tray in the VPC-MAX
calibration screen (View B).
See the Main Display Operation Manual for detailed
instructions under the topic VPC-MAX Calibration at
Installation.
3. Once calibrated, drive the tray rearward until it is at the
minimum working position of 4.00 m as indicted in the
calibration screen (View C).
To Next Page
Loading...
Need help?
General
