Mariner 70 - Disassembly; Tilt Ram Removal - Power Trim System Removed from Outboard

90-13645--2 495 6B-23POWER TRIM
TILT RAM REMOVAL - POWER TRIM SYSTEM
REMOVED FROM OUTBOARD
Insure Trim System Is Depressurized Prior To Tilt
Ram Removal.
CAUTION
1. Remove cross pin.
5136
6
a
a - Cross Pin (Remove as shown)
2. Remove lower swivel pin.
51355
a
a - Lower Swivel Pin (Remove as shown)
Disassembly
1. Secure tilt ram in a soft jawed vise. Remove tilt rod
and cap.
51364
51337
91-74951
a
b
c
a - Cap (Turn counterclockwise to remove)
b - Spanner Wrench (91-74951)
c - Tilt Rod - Pull to remove
2. Clamp tilt rod in a soft jawed vise. Remove bolt or
nut as applicable to disassemble rod assembly.
Remove O-ring.
51378
51340
a
b
a - Bolt (Design 1) or Stud/Nut (Design 2)
b - O-ring