Marport Catch Sensor - Catch Hybrid PI; Catch Hybrid 70

Catch Sensors | V1 | Sensor Configuration
Catch Hybrid PI
About this task
Catch hybrid PI firmware is compatible with Simrad PI, Marport and Scanmar systems.
Sensors can communicate with Simrad PI and Marport or Scanmar systems at the same
time.
Catch data are sent to Simrad PI system and to Marport or Scanmar systems. Depth,
temperature, pitch and roll data are sent only to Marport or Scanmar systems.
Procedure
1.
Click the tab Catch.
2.
The settings for catch data sent at 40kHz and settings for depth, temperature, pitch
and roll data are the same as above.
3.
From Catch PI Frequency, choose a frequency to communicate with a Simrad PI
receiver.
4.
From Catch PI Telegram, choose the update rate of data sent to Simrad PI receiver.
The update of data is quicker when Fast is set, but this reduces the battery life.
•
Telegram Fast: sends a full status signal every 5 sec. / Empty status every 5.5 sec.
•
Telegram Normal: full status every 32 sec. / Empty status every 34 sec.
•
Telegram Slow: full status every 123 sec. / Empty status every 126 sec.
5.
If you need to deactivate the transmission of data to PI system, click the tab Catch and
from Catch PI Activation, select No.
Catch Hybrid 70
About this task
Catch hybrid 70 firmware is compatible with Marport, Scanmar, Simrad and Wesmar
systems. Sensors can emit at 2 frequencies: 40kHz (Marport, Scanmar) and 70kHz
(Simrad, Wesmar).
Catch data are sent at 70kHz and 40kHz frequencies. Depth, temperature, pitch and roll
data are sent only to 40kHz (Marport, Scanmar).
Procedure
1.
The settings for catch data sent at 40kHz and settings for depth, temperature, pitch
and roll data are the same as above.
2.
From Catch 70kHz Channel, choose an appropriate channel for Simrad or Wesmar
receivers.
3.
If you need to deactivate the transmission of data at 70kHz, click the tab Catch and
from Catch 70 kHz Activation, select No.
| 35