Catch Sensors | V1 | Servicing and Maintenance
Maintenance Checklist
We recommend you to follow this maintenance schedule for better performance and to
avoid any trouble with the equipment.
Interval Maintenance operation
Before use
• Check that all attachement equipment
are not worn or torn. Replace when
appropriate.
• Check that the sensor is clean. See
Cleaning the Sensor on page 60 for
cleaning procedures.
After use Wash the sensor with fresh water.
Between uses
• When the sensor is not in use, store
in a dry area, without humidity, at a
temperature between -10° and 70 °C (14
to 158 °F).
• If you put the sensor into storage for
a long period of time, charge it once
in a while. If you do not, batteries can
become inoperable.
Every 2 years Return the sensor to an approved Marport
dealer for inspection and maintenance.
Replacing Parts
Qualified Marport technicians can remove and replace the following parts if they are
damaged.
Replacing the Battery
Before you begin
For this task you need the following tools:
• 6 mm Allen key
• Tape
• O-ring lubricant
About this task
Only qualified Marport technicians can do this task.
| 61
To Next Page
Loading...