Marport Catch Sensor - Appendix A: Frequency Plan

Catch Sensors | V1 | Appendix A: Frequency Plan
Appendix A: Frequency Plan
When the system is installed, you can add sensors to it. It is important to carefully plan
the setup of your sensors before adding them to the system. You can create a table with a
list of frequencies and complete it when you add sensors.
Type of sensor Interval between frequencies
PRP (e.g. Catch sensor, Trawl Speed, Door
Spread sensor...)
100 Hz
NBTE (e.g. Speed Explorer, Trawl Explorer,
Catch Explorer, Door Sounder)
800 Hz
HDTE Normal 1200 Hz / Wide band 2000 Hz
| 92