Catch Sensors | V1 | Servicing and Maintenance
3.
Install the new pull-cord assembly on the side or on the end cap of the sensor.
4.
Apply anti-seize on the four screw threads, then tighten the screws with the 9/64 size
Allen key.
What to do next
You need to calibrate the new catch sensor. See Calibrating the Catch Sensor on page 22.
Replacing the Catch Magnet
You can replace the magnet that is part of the pull cord assembly when the magnet is
broken.
Before you begin
For this task you need the following tools:
• 9/64" Allen key
• Drift punch / pliers
• Arbor press / hammer
• Anti-seize
About this task
Only qualified Marport technicians can do this task.
| 66
To Next Page
Loading...