EasyManua.ls Logo

Matrix mvBlueFOX3 - Page 1074

Matrix mvBlueFOX3
1974 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
On: Enable the selected trigger.
TriggerSource - - - Line4,
Line5,
Timer1Start,
Timer2Start,
Timer1End,
Timer2End,
Timer1Active,
Timer2Active,
mvLogicGateOR1Output,
mvLogicGateOR2Output,
mvLogicGateOR3Output,
mvLogicGateOR4Output,
UserOutput0,
UserOutput1,
UserOutput2,
UserOutput3,
Counter1End,
Counter2End,
Counter3End,
Counter4End,
Counter1Active,
Counter2Active,
Counter3Active,
Counter4Active,
Software,
Off
Specifies the internal signal or
physical input Line to use as the
trigger source. The selected trigger
must have its TriggerMode set to On.
Line4: Specifies which physical line
(or pin) and associated I/O control
block to use as external source for
the trigger signal.
Line5: Specifies which physical line
(or pin) and associated I/O control
block to use as external source for
the trigger signal.
Timer1Start: Specifies which Timer
signal to use as internal source for
the trigger.
Timer2Start: Specifies which Timer
signal to use as internal source for
the trigger.
Timer1End: Specifies which Timer
signal to use as internal source for
the trigger.
Timer2End: Specifies which Timer
signal to use as internal source for
the trigger.
Timer1Active: Specifies the internal
signal or physical input Line to use
as the trigger source.
Timer2Active: Specifies the internal
signal or physical input Line to use
as the trigger source.
mvLogicGateOR1Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR2Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR3Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR4Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
UserOutput0: Specifies which User
Output bit signal to use as internal
source for the trigger.
UserOutput1: Specifies which User
Output bit signal to use as internal
source for the trigger.
UserOutput2: Specifies which User
Output bit signal to use as internal
source for the trigger.
20 Appendix A.1 Pregius CMOS specific camera / sensor data
1066

Table of Contents