UserOutput3: Specifies which User
Output bit signal to use as internal
source for the trigger.
Counter1End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter2End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter3End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter4End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter1Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter2Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter3Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter4Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Software: Specifies that the trigger
source will be generated by software
using the TriggerSoftware command.
Off: Specifies the internal signal or
physical input Line to use as the
trigger source.
TriggerActivation - - -
LevelHigh,
LevelLow,
mvNone
Specifies the activation mode of the
trigger.
LevelHigh: Specifies that the trigger
is considered valid as long as the
level of the source signal is high.
LevelLow: Specifies that the trigger
is considered valid as long as the
level of the source signal is low.
mvNone: Specifies the activation
mode of the trigger.
TriggerDelay 0.000 UINT_MAX - -
Specifies the delay in microseconds
(us) to apply after the trigger
reception before activating it. (us)
TriggerSoftware@i - - - -
Generates an internal trigger.
TriggerSource must be set to
Software.
mvAcquisitionFrameRateLimitMode - - -
20 Appendix A.1 Pregius CMOS specific camera / sensor data
1067
To Next Page
Loading...