trigger signal becomes active and
terminated when it goes back to the
inactive state.
mvTimestampReset: Selects the
type of trigger to configure.
FrameBurstStart: Selects a trigger
starting the capture of the bursts of
frames in an acquisition.
AcquisitionBurstFrameCount controls
the length of each burst unless a
FrameBurstEnd trigger is active. The
total number of frames captured is
also conditioned by
AcquisitionFrameCount if
AcquisitionMode is MultiFrame.
FrameBurstActive: Selects a trigger
controlling the duration of the capture
of the bursts of frames in an
acquisition.
TriggerMode - - -
Off,
On
Controls if the selected trigger is
active.
Off: Disables the selected trigger.
On: Enable the selected trigger.
TriggerSource - - - Line4,
Line5,
Timer1Start,
Timer2Start,
Timer1End,
Timer2End,
Timer1Active,
Timer2Active,
mvLogicGateOR1Output,
mvLogicGateOR2Output,
mvLogicGateOR3Output,
mvLogicGateOR4Output,
UserOutput0,
UserOutput1,
UserOutput2,
UserOutput3,
Counter1End,
Counter2End,
Counter3End,
Counter4End,
Counter1Active,
Counter2Active,
Counter3Active,
Counter4Active,
Software,
Off
Specifies the internal signal or
physical input Line to use as the
trigger source. The selected trigger
must have its TriggerMode set to On.
Line4: Specifies which physical line
(or pin) and associated I/O control
block to use as external source for
the trigger signal.
Line5: Specifies which physical line
(or pin) and associated I/O control
block to use as external source for
the trigger signal.
Timer1Start: Specifies which Timer
signal to use as internal source for
the trigger.
Timer2Start: Specifies which Timer
signal to use as internal source for
the trigger.
Timer1End: Specifies which Timer
signal to use as internal source for
the trigger.
Timer2End: Specifies which Timer
signal to use as internal source for
the trigger.
Timer1Active: Specifies the internal
signal or physical input Line to use
as the trigger source.
Timer2Active: Specifies the internal
20 Appendix A.1 Pregius CMOS specific camera / sensor data
1164