Matrix mvBlueFOX3 - Page 1625

Describes the data the LUT is operating
on
Gray: The LUT is operating on gray data
mvLUTMapping - - - map_10To12
Describes the mapping of the LUT
map_10To12: The LUT maps 10 bit input
data to 12 bit output data.
Feature Name Min Max Inc
Valid
Values
Documentation
TestControl A category for Test Control features.
TestPendingAck 0 INT_MAX 1 -
Tests the device's pending
acknowledge feature. When this
feature is written, the device waits a
time period corresponding to the
value of TestPendingAck before
acknowledging the write. (ms)
TestEventGenerate@i - - - - Generates a Test Event.
Feature Name Min Max Inc
Valid
Values
Documentation
TransportLayerControl
Category that contains the
transport Layer control
features.
PayloadSize INT_MIN INT_MAX 1 -
Provides the number of
bytes transferred for each
image or chunk on the
stream channel. This
includes any end-of-line,
end-of-frame statistics or
other stamp data. This is the
total size of data payload for
a data block.
mvU3VPHYErrorCount 0 INT64_MAX 1 -
Counts the number of errors
on the PHY interface.
mvU3VLNKErrorCount 0 INT64_MAX 1 -
Counts the number of errors
on the USB3 link.
Feature Name Min Max Inc
Valid
Values
Documentation
UserSetControl
A category that contains the User Set
control features.
UserSetSelector - - - Default,
UserSet1,
UserSet2,
UserSet3,
UserSet4
Selects the feature User Set to load,
save or configure.
Default: Selects the factory setting user
set.
UserSet1: Selects the user set 1.
21 Appendix A.2 CMOS specific camera / sensor data
1617