Matrix mvBlueFOX3 - Page 1669

doing the capture of a Frame.
mvReadOutActive: Selects which
internal acquisition or I/O source
signal to output on the selected
Line.
LineActive: Device is currently
doing the capture of a Line.
mvExposureAndAcquisitionActive:
Selects which internal acquisition
or I/O source signal to output on
the selected Line.
FrameTriggerWait: Device is
currently waiting for a Frame start
trigger.
mvTemperatureOutOfRange:
Selects which internal acquisition
or I/O source signal to output on
the selected Line.
mvLogicGateOR1Output: Selects
which internal acquisition or I/O
source signal to output on the
selected Line.
mvLogicGateOR2Output: Selects
which internal acquisition or I/O
source signal to output on the
selected Line.
mvLogicGateOR3Output: Selects
which internal acquisition or I/O
source signal to output on the
selected Line.
mvLogicGateOR4Output: Selects
which internal acquisition or I/O
source signal to output on the
selected Line.
mvExposureActive: Selects which
internal acquisition or I/O source
signal to output on the selected
Line.
LineInverter - - -
0,
1
Controls the inversion of the
signal of the selected input or
output Line.
mvLineDebounceTimeRisingEdge 0 5000 1 -
Sets the debounce time in micro
seconds for low to high
transitions.
mvLineDebounceTimeFallingEdge 0 5000 1 -
Sets the debounce time in micro
seconds for high to low
transitions.
LineStatusAll INT_MIN INT_MAX 0x1 -
Returns the current status of all
available Line signals at time of
polling in a single bitfield.
21 Appendix A.2 CMOS specific camera / sensor data
1661