Matrix mvBlueFOX3 - Page 1670

UserOutputSelector - - -
UserOutput0,
UserOutput1,
UserOutput2,
UserOutput3
Selects which bit of the User
Output register will be set by
UserOutputValue.
UserOutput0: Selects the bit 0 of
the User Output register.
UserOutput1: Selects the bit 1 of
the User Output register.
UserOutput2: Selects the bit 2 of
the User Output register.
UserOutput3: Selects the bit 3 of
the User Output register.
UserOutputValue - - -
0,
1
Sets the value of the bit selected
by UserOutputSelector.
UserOutputValueAll INT_MIN INT_MAX 0x1 -
Sets the value of all the bits of the
User Output register. It is subject
to the UserOutputValueAllMask.
UserOutputValueAllMask INT_MIN INT_MAX 0x1 -
Sets the write mask to apply to
the value specified by
UserOutputValueAll before writing
it in the User Output register. If
the UserOutputValueAllMask
feature is present, setting the user
Output register using
UserOutputValueAll will only
change the bits that have a
corresponding bit in the mask set
to one.
Feature Name Min Max Inc
Valid
Values
Documentation
mvFrameAverageControl
Contains features to control the
frame averaging engine.
mvFrameAverageEnable - - -
0,
1
Enables the frame averaging
engine.
mvFrameAverageMode - - - mvNTo1
Sets the frame average
operating mode.
mvNTo1: Sets the frame average
operating mode.
mvFrameAverageFrameCount 2 16 1 -
Here you specify the frame count
used for the calculation of the
frame average.
Feature Name Min Max Inc
Valid
Values
Documentation
mvDefectivePixelCorrectionControl
Contains features to control the
device's defective pixel correction
parameters.
21 Appendix A.2 CMOS specific camera / sensor data
1662