Power the camera using the power supply and the hirose connector.2.
Wait until the status LED turns blue.3.
Open the tool mvDeviceConfigure ,4.
set a friendly name ,5.
and register the MV device for DirectShow .6.
Note:
In some cases it could be necessary to repeat step 5.
18.2.5.4 Working with VLC Media Player
Start VLC Media Player.1.
Click on "Media -> Open Capture Device..." .
Figure 2: Open Capture Device...
2.
Select the tab "Device Selection" .3.
In the section "Video device name" , select the friendly name of the MV device:
Figure 3: Video device name
4.
18 Use cases
160
To Next Page
Loading...