Matrix mvBlueFOX3 User Manual

DeviceRegistersStreamingEnd@i - - - -
Announce the end of
registers streaming. This will
do a register set validation
for consistency and activate
it. This will also update the
DeviceRegistersValid flag.
mvDeviceProcessingUnitSelector 0 0 1 -
Selects the device
processing unit.
mvDeviceProcessingUnit - - - mvFrameAverage
The processing unit to
activate for the selected
processing unit.
mvFrameAverage: Selects
the frame average engine for
this processing unit.
mvDeviceStatusLEDEnable - - -
0,
1
If enabled, the color of the
LED changes depending on
the state of the camera.
Otherwise the LED is Off.
mvDevicePowerMode - - -
mvActive,
mvStandby
Selects the device power
mode.
mvActive: Puts the device to
power-active mode.
Afterwards features will be
restored to the values they
had before entering power
down mode. LUT values are
not restored.
mvStandby: Puts the device
in power-saving mode. In this
mode the device will only
consume up to 20 percent of
its normal power
consumption.
mvDeviceStandbyTimeoutEnable - - -
0,
1
If enabled, the device
switches to standby after a
configurable time if no
register is read.
mvDeviceStandbyTimeout 10 60 1 -
Defines the time in seconds
after which the device
automatically switches to
standby if no register is read.
DeviceLinkSelector 0 0 1 -
Selects which Link of the
device to control.
DeviceLinkSpeed 0 INT_MAX 1 -
Indicates the speed of
transmission negotiated on
the specified Link. (Bps)
DeviceLinkThroughputLimitMode - - -
21 Appendix A.2 CMOS specific camera / sensor data
1768

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English