Matrix mvBlueFOX3 - Page 1964

or I/O source signal to output on
the selected Line.
FrameTriggerWait: Device is
currently waiting for a Frame start
trigger.
mvTemperatureOutOfRange:
Selects which internal acquisition
or I/O source signal to output on
the selected Line.
mvLogicGateOR1Output: Selects
which internal acquisition or I/O
source signal to output on the
selected Line.
mvLogicGateOR2Output: Selects
which internal acquisition or I/O
source signal to output on the
selected Line.
mvLogicGateOR3Output: Selects
which internal acquisition or I/O
source signal to output on the
selected Line.
mvLogicGateOR4Output: Selects
which internal acquisition or I/O
source signal to output on the
selected Line.
mvExposureActive: Selects which
internal acquisition or I/O source
signal to output on the selected
Line.
LineInverter - - -
0,
1
Controls the inversion of the
signal of the selected input or
output Line.
mvLineDebounceTimeRisingEdge 0 5000 1 -
Sets the debounce time in micro
seconds for low to high
transitions.
mvLineDebounceTimeFallingEdge 0 5000 1 -
Sets the debounce time in micro
seconds for high to low
transitions.
LineStatusAll INT_MIN INT_MAX 0x1 -
Returns the current status of all
available Line signals at time of
polling in a single bitfield.
UserOutputSelector - - - UserOutput0,
UserOutput1,
UserOutput2,
UserOutput3
Selects which bit of the User
Output register will be set by
UserOutputValue.
UserOutput0: Selects the bit 0 of
the User Output register.
UserOutput1: Selects the bit 1 of
the User Output register.
UserOutput2: Selects the bit 2 of
21 Appendix A.2 CMOS specific camera / sensor data
1956