the User Output register.
UserOutput3: Selects the bit 3 of
the User Output register.
UserOutputValue - - -
0,
1
Sets the value of the bit selected
by UserOutputSelector.
UserOutputValueAll INT_MIN INT_MAX 0x1 -
Sets the value of all the bits of the
User Output register. It is subject
to the UserOutputValueAllMask.
UserOutputValueAllMask INT_MIN INT_MAX 0x1 -
Sets the write mask to apply to
the value specified by
UserOutputValueAll before writing
it in the User Output register. If
the UserOutputValueAllMask
feature is present, setting the user
Output register using
UserOutputValueAll will only
change the bits that have a
corresponding bit in the mask set
to one.
Feature Name Min Max Inc
Valid
Values
Documentation
mvFrameAverageControl
Contains features
to control the
frame averaging
engine.
mvFrameAverageEnable - - -
0,
1
Enables the frame
averaging engine.
mvFrameAverageMode - - - mvNTo1
Sets the frame
average operating
mode.
mvNTo1: Sets the
frame average
operating mode.
mvFrameAverageFrameCount 2 16 1 -
Here you specify
the frame count
used for the
calculation of the
frame average.
Feature Name Min Max Inc Valid Values Documentation
LUTControl
A category that includes the LUT control
features.
LUTSelector - - - Red,
Green,
Blue,
Luminance
Selects which LUT to control.
Red: Selects the Red LUT.
Green: Selects the Green LUT.
Blue: Selects the Blue LUT.
21 Appendix A.2 CMOS specific camera / sensor data
1957
To Next Page
Loading...