Figure 1: wxPropView started
Depending on the camera spectrum (gray or color sensor), it will automatically pre-set the camera
so that image quality is usually as best as possible.
"For all cameras:"
Image format is chosen as 10 bit (if possible) as a good compromise on image quality and speed.
It will further set
"Exposure" to Auto,•
"Gain" to Auto,•
"Frame rate" to Auto based on current settings of the camera, and•
switches camera into continuous mode•
"In case of gray:"
The above settings will be also applied whenever the "Gray Preset" button is pressed. For gray
cameras it is herewith assumed that image processing prefers a linear camera response.
"In case of color:"
It will additionally set
"White balance" in the camera to Auto, and will apply•
a host based moderate "Gamma correction" (1.8), and lastly it will apply•
11 GUI
70
To Next Page
Loading...
Need help?
General