EasyManua.ls Logo

Matrix mvBlueFOX3 - Page 823

Matrix mvBlueFOX3
1974 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
also conditioned by
AcquisitionFrameCount if
AcquisitionMode is MultiFrame.
FrameBurstActive: Selects a trigger
controlling the duration of the capture
of the bursts of frames in an
acquisition.
TriggerMode - - -
Off,
On
Controls if the selected trigger is
active.
Off: Disables the selected trigger.
On: Enable the selected trigger.
TriggerSource - - - Line4,
Line5,
Timer1Start,
Timer2Start,
Timer1End,
Timer2End,
Timer1Active,
Timer2Active,
mvLogicGateOR1Output,
mvLogicGateOR2Output,
mvLogicGateOR3Output,
mvLogicGateOR4Output,
UserOutput0,
UserOutput1,
UserOutput2,
UserOutput3,
Counter1End,
Counter2End,
Counter3End,
Counter4End,
Counter1Active,
Counter2Active,
Counter3Active,
Counter4Active,
Software,
Off
Specifies the internal signal or
physical input Line to use as the
trigger source. The selected trigger
must have its TriggerMode set to On.
Line4: Specifies which physical line
(or pin) and associated I/O control
block to use as external source for
the trigger signal.
Line5: Specifies which physical line
(or pin) and associated I/O control
block to use as external source for
the trigger signal.
Timer1Start: Specifies which Timer
signal to use as internal source for
the trigger.
Timer2Start: Specifies which Timer
signal to use as internal source for
the trigger.
Timer1End: Specifies which Timer
signal to use as internal source for
the trigger.
Timer2End: Specifies which Timer
signal to use as internal source for
the trigger.
Timer1Active: Specifies the internal
signal or physical input Line to use
as the trigger source.
Timer2Active: Specifies the internal
signal or physical input Line to use
as the trigger source.
mvLogicGateOR1Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR2Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR3Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR4Output: Specifies
20 Appendix A.1 Pregius CMOS specific camera / sensor data
815

Table of Contents