Matrix mvBlueFOX3 - Page 824

the internal signal or physical input
Line to use as the trigger source.
UserOutput0: Specifies which User
Output bit signal to use as internal
source for the trigger.
UserOutput1: Specifies which User
Output bit signal to use as internal
source for the trigger.
UserOutput2: Specifies which User
Output bit signal to use as internal
source for the trigger.
UserOutput3: Specifies which User
Output bit signal to use as internal
source for the trigger.
Counter1End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter2End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter3End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter4End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter1Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter2Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter3Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter4Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Software: Specifies that the trigger
source will be generated by software
using the TriggerSoftware command.
Off: Specifies the internal signal or
physical input Line to use as the
trigger source.
TriggerActivation - - - RisingEdge,
FallingEdge,
AnyEdge,
mvNone
Specifies the activation mode of the
trigger.
RisingEdge: Specifies that the trigger
is considered valid on the rising edge
of the source signal.
FallingEdge: Specifies that the
trigger is considered valid on the
falling edge of the source signal.
20 Appendix A.1 Pregius CMOS specific camera / sensor data
816