AnyEdge: Specifies that the trigger is
considered valid on the falling or
rising edge of the source signal.
mvNone: Specifies the activation
mode of the trigger.
TriggerDelay 0.000 UINT_MAX - -
Specifies the delay in microseconds
(us) to apply after the trigger
reception before activating it. (us)
TriggerSoftware@i - - - -
Generates an internal trigger.
TriggerSource must be set to
Software.
mvAcquisitionFrameRateLimitMode - - -
mvDeviceLinkThroughput,
mvDeviceMaxSensorThroughput
Controls the calculation of the
maximum frame rate.
mvDeviceLinkThroughput: Uses the
highest possible frame rate
depending on bandwidth and sensor
settings.
mvDeviceMaxSensorThroughput:
Maximum frame rate the sensor can
provide depending on AOI and pixel
clock. Note: Images might be
buffered in the cameras memory.
This can result in delayed images.
AcquisitionFrameRateEnable - - -
0,
1
Controls if the AcquisitionFrameRate
feature is writable and used to
control the acquisition rate.
Otherwise, the acquisition rate is
implicitly controlled by the
combination of other features like
ExposureTime, etc...
mvAcquisitionFrameRateEnable - - -
Off,
On
This feature is deprecated (See
AcquisitionFrameRateEnable). It was
used to enable the
'AcquisitionFrameRate' feature.
Off: The acquisition frame rate is set
automatically to the limit, calculated
according to
'mvAcquisitionFrameRateLimitMode'
feature.
On: The acquisition frame rate is set
by the 'AcquisitionFrameRate'
feature.
AcquisitionFrameRate 0.100 2000.000 - -
Controls the acquisition rate (in
Hertz) at which the frames are
captured. (Hz)
AcquisitionFrameCount 1 65534 1 -
Number of frames to acquire in
MultiFrame Acquisition mode.
mvAcquisitionMemoryMode - - - Default
20 Appendix A.1 Pregius CMOS specific camera / sensor data
817
To Next Page
Loading...