mvRecord is used to store frames in
memory. mvPlayback transfers
stored frames. mvPretrigger stores
frames in memory to be transferred
after trigger.
Default: Default memory mode.
mvPretriggerFrameCount 0 34 1 -
Number of frames to acquire before
the occurrence of an AcquisitionStart
or AcquisitionActive trigger.
mvAcquisitionMemoryMaxFrameCount INT_MIN INT_MAX 1 -
Maximum number of frames that can
be recorded in the current
configuration.
mvAcquisitionMemoryFrameCount 0 34 1 -
The number of frames currently
stored in the frame buffer. If this
value keeps increasing this can
indicate a bandwidth/transmission
problem.
mvAcquisitionMemoryAOIParameterChanged INT_MIN INT_MAX 1 -
AOI and/or binning parameter
changed after last Acquisition.
AcquisitionBurstFrameCount 1 65534 1 -
Number of frames to acquire for
each FrameBurstStart trigger.
mvResultingFrameRate 0.100 13.000 - - Shows the resulting frame rate.
Feature Name Min Max Inc Valid Values Documentation
CounterAndTimerControl
A category that contains
the Counter and Timer
control features.
CounterSelector - - -
Counter1,
Counter2,
Counter3,
Counter4
Selects which Counter to
configure.
Counter1: Selects the
counter 1.
Counter2: Selects the
counter 2.
Counter3: Selects the
counter 3.
Counter4: Selects the
counter 4.
CounterEventSource - - - Off,
AcquisitionStart,
AcquisitionEnd,
FrameStart,
FrameEnd,
ExposureStart,
ExposureEnd,
Line4,
Line5,
Counter1End,
Select the events that will
be the source to
increment the Counter.
Off: Counter is stopped.
AcquisitionStart: Counts
the number of Acquisition
Start.
AcquisitionEnd: Counts
the number of Acquisition
End.
20 Appendix A.1 Pregius CMOS specific camera / sensor data
818
To Next Page
Loading...