Matrix Sparsh VP110

254 Matrix SPARSH VP110 User Guide
• The variable value is not applicable to all events. For example, the variable value “MUTE” is only
applicable when the IP phone is during a call.
• When authentication is required, you must enter
“p=login&q=login&username=xxx&pwd=yyy&jumpto=URI&” before the variable “key”. xxx refers to the
login user name and yyy refers to the login password.
For security reasons, IP phones do not receive and handle HTTP/HTTPS GET requests by default. You need to
specify the trusted IP address for action URI. When the IP phone receives a GET request from the trusted IP
address for the first time, the LCD screen prompts the message "Allow Remote Control?". You can specify one or
more trusted IP addresses on the IP phone, or configure the IP phone to receive and handle the URI from any IP
address.
Procedure
Specify the trusted IP address for action URI using the configuration files or locally.
Reset Resetaphone.
ATrans=xxx Performasemi‐attended/attendedtransfertoxxx.
BTrans=xxx Performablindtransfertoxxx.
CALLEND Endacall.
phonecfg=get[&accounts=x][&dnd=x][&fw=x]
Getfirmwareversion,registration,DNDorforward
configurationinformation.
Thevalidvalueof“x”is0or1,0meansyoudonotneedtoget
configurationinformation.1meansyouwanttoget
conf
igurationinformation.
Note:ThevalidURIis:
http(s)://phoneIPaddr ess/
servlet?phonecfg=get[&accounts=x][&dnd=x][&fw=x]
ConfigurationFile <MAC>.cfg
SpecifythetrustedIPaddress(es)for
sendingtheactionURItotheIP
phone.
Formoreinformation,refer
“AppendixD‐Configuration
Parameters”.