Matrix Sparsh VP110

428 Matrix SPARSH VP110 User Guide
Failover Mode
Range 10to2147483647
Example
account.1.fallback.timeout=120
Parameter-
account.X.sip_server.Y.failback_mode
ConfigurationFile
<MAC>.cf g
Description
ConfiguresthemodefortheIPphonetoretrythe
primaryserverinfailovermode.
Xis1.
Yrangesfrom1to2.
Format Integer
DefaultValue
0
Range
Validvaluesare:
0‐newRequests:allrequestsaresenttotheprimary
serverfirst,regardlessofthelastusedserver.
1‐DNSTTL:theIPphoneretriestosendrequeststo
theprimaryserverafterthetime‐outequaltothe
DNSTTLconfiguredfortheserverthattheIPphone
isregisteredto.
2‐registration:theIPphoneretriestosend
REGISTERrequeststotheprimaryserverwhen
registrationrenewal.
3‐duration:theIPphoneretriestose
ndrequests
totheprimaryserverafterthetime‐outdefined
bytheaccount.X.sip_server.Y.failback_timeout
parameter.
Example account.1.sip_server.1.failback_mode=0
Parameter-
account.X.sip_server.Y.failback_timeout
ConfigurationFile
<MAC>.cf g
Description
Configuresthetime‐out(inseconds)fortheIPphone
toretrytosendrequeststotheprimaryserverafter
failingovertothecurrentworkingserverwhenthe
parameter“account.X.sip_server.Y.failback_mode”is
setto3(duration).
Ifyousettheparameterto0,theIPphonewillnot
sendre
queststotheprimaryserveruntilafailover
eventoccurswiththecurrentworkingserver.
Xis1.
Yrangesfrom1to2.
Format Integer
DefaultValue 3600
Range 0,60to65535