Matrix Sparsh VP110 - Page 421

Matrix SPARSH VP110 User Guide 413
Incoming Intercom calls
Parameter-
features.dtmf.transfer
ConfigurationFile
<MAC>.cfg
Description
ConfigurestheDTMFdigitstobetransmittedto
completethetransfer.
Note
:Itworksonlyiftheparameter
“features.dtmf.replace_tran”issetto1(Enabled).
Format String
DefaultValue Blank
Range
Validvaluesare:0‐9,*,#andA‐D.
Stringwithin32characters
Example features.dtmf .transfer=123
Parameter‐
features.intercom.allow
ConfigurationFile
<MAC>.cfg
Description
EnablesordisablestheIPphonetoautomatically
answeranincomingintercomcall.
Ifitissetto0(Disabled),theIPphonewillreject
incomingintercomcallsandsendsabusysignalto
thecaller.
Ifitissetto1(Enabled),theIPphonewill
automaticallyansweraninc
omingintercomcall.
Format Boolean
DefaultValue 1
Range
Validvaluesare:
0‐Disabled
1‐Enabled
Example
features.intercom.allow=1
Parameter‐
features.intercom.mute
ConfigurationFile
<MAC>.cfg
Description
EnablesordisablestheIPphonetomutethe
microphonewhenansweringanintercomcall.
Ifitissetto0(Disabled),themicrophoneisun‐muted
forincomingcalls.
Ifitissetto1(Enabled),themicrophoneismute dfor
interc omcalls.