Matrix Sparsh VP110

Matrix SPARSH VP110 User Guide 51
To configure PPPoE via web user interface:
• Click on Network->Basic.
• In the IPv4 Config block, click PPPoE.
• Enter the User Name and Password in corresponding fields.
• Click Confirm to save the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
• Click OK to reboot the IP phone.
To configure PPPoE via phone user interface:
• Press Menu->Settings->Advanced Settings (password: 1234) ->Network->WAN Port and press the
Enter soft key.
• Press to select IPv4 and press the Enter soft key.
• Press
to select PPPoE IP Client and press the Enter soft key.
• Enter the user name and password in corresponding fields.
• Press the Save soft key to save the change.
• Reboot the IP phone to apply the changes.