Matrox Extio 3 Series - Page 14

14 Matrox Extio 3 Series – User Guide
some settings related to this operation mode (such as Currently adapted for WAN , MTU ,
and
Encoding quality ). If not, you need to apply the settings for this mode from the Extio
Central Manager software.
5 Install your Extio Central Manager software – see “Installing Matrox Extio Central
Manager software”, page 62.
6 Configure your Extio devices through the Extio Central Manager software (Network
Administrator).
Note : You must discover the receivers manually ( Manual device
discovery
), then discover the transmitters using Transmitter discovery from the receiver
settings. For more information on using the Extio Central Manager software, see the
Matrox Extio Central Manager User Guide.
 Manually discover the receivers ( Manual device discovery  Scan a list of IP
addresses
).
 If the receivers and transmitters are on different subnets, make sure to configure the
receiver units to scan the transmitter subnets (
Receiver  Settings  Transmitter
discovery
). If not, in the device tile, you will see a settings icon with a popup message
“
Transmitter discovery settings are not set. Receiver will not be able to see any
transmitter
.”
 Assign user(s) to the devices using Manage users .
 Allow the receiver and transmitter units to connect to one another using Connection
broker
.
 Set a value for Sharing mode ( Transmitter  Settings  Connection  Sharing
mode
 Guest connections ).
 Press the Change button beside the Currently Adapted for LAN field ( Receiver 
Settings  Network  Adapt for WAN / LAN ) to automatically update certain
settings for a private WAN configuration.
 Set the Maximum Transmission Unit ( MTU ) to the recommended 1400 . Note : This
is set automatically to 1400 when you apply the
Currently Adapted for WAN settings,
or when you select
Reset configuration in the Firmware updater and choose the
Networked-Enable Internet / WAN with Site-to-Site VPN option in the Select the
operation mode
screen.
 Set the Encoding quality to Low ( Transmitter  Settings  Streaming ). Note : This
is set automatically to
Low when you apply the Currently Adapted for WAN settings,
or when you select
Reset configuration in the Firmware updater and choose the
Networked-Enable Internet / WAN with Site-to-Site VPN option in the Select the
operation mode
screen.
 Set a value for Network congestion control ( Transmitter  Settings  Streaming ).
The values are
Off , Low , Mid , and High .