SAFETY INSTRUCTIONS2 - 2
D-MAXE with OI-TS www.maxcessintl.comMI 2-292 1 C
Symbols
Warning/caution - dangerous area
Reference to general hazards that may result in bodily injuries
or damage to the device
Warning/caution - danger due to crushing
Refers to danger of injury caused by crushing
Warning/caution - danger due to cutting
Refers to danger of injury caused by cutting
Additional symbols
– This en dash is followed by an enumeration.
∙ This dot is followed by a prompt to do something.
Note:
Reference to important information.
Preventing hazards
Installation and
commissioning ∙ Damaged modules of the D-MAXE system must not be
installed or placed in operation.
∙ Assembly work must be performed while the machine is
stopped and protected against being turned on again.
∙ All assembly tasks must only be performed when there is no
electrical power in the system.
∙ The D-MAXE system must only be placed in operation if all
components are securely assembled.
∙ Electrical connections on the modules of the D-MAXE system
must only be made or disconnected when the electrical
power is turned off. Failure to follow these instructions may
result in damage to the D-MAXE system.
∙ The parameters specified in Section
Technical Data
must be
observed.
To Next Page
Loading...
Need help?
General
