Maxcess FIFE D-MAXE 2 - 1 Y.9 Service; 1 Y.9.1 Measurements; 1 Y.9.2 Simulate Outputs

MENUS: 1Y.9 SERVICE7 - 27
D-MAXE with OI-TS www.maxcessintl.comMI 2-292 1 C
1y.9 Service The purpose of these menus is to show information about
settings of the D-MAXE system that is important for Customer
Service.
"Manual" mode:
– All buttons are available.
"Servo Center" and "Automatic" mode:
– Only selected buttons are available.
1y.9.1 Measurements Display of values of the D-MAXE system
1y.9.1.1 Sensors
1y.9.1.2 Encoder
1y.9.1.3 Digital Inputs (Connection X1)
1y.9.1.7 Measured Values
1y.9.1.9 Sensor Current
1y.9.2 Simulate Outputs Used to test components connected to the digital outputs