TROUBLESHOOTING10 - 5
D-MAXE with OI-TS www.maxcessintl.comMI 2-292 1 C
Icon Indicates Possible error remedy
Error messages
A threshold of the travel path has
been reached. It is only possible to
move in one direction - away from
this limit.
If this message appears even though no
threshold has been reached, the thresholds
have been moved.
To restore the basic values, switch to "Servo-
Center" mode and approach the servo-center
position.
If the error persists, check the parameters in
1y.4.2 Gain, page 7‑10
and
1y.4.3 Polarity,
page 7‑10
.
Flashing
The web speed for web speed-
dependent guiding is equal to 0.
However, if the web speed is not equal to 0,
check the signal for web speed.
and
The ASC function on the selected
actuator has been activated and
triggered and the motor is locked.
If locking was not intended, check the sensor
signal and ASC thresholds.
see
1y.9.1.1 Sensors, page 7‑27
and
1y.3.y6 ASC, page 7‑4
The motor is locked because of an
external signal (e.g. PIOX, fieldbus,
application control).
If you did not intend for the motor to be
locked, check the digital inputs. It is possible
that external locking is active
see
1y.9.1.3 Digital Inputs (Connection X1),
page 7‑27
If there is customer-specific programming,
refer to the "Supplementary Operating
Instructions" in the system documentation for
information about the X1 parallel interface.
or
The D-MAXE system is expecting
commands from external devices.
The devices may not be connected to the
network.
Check whether these devices are correctly
connected to the network.
To Next Page
Loading...
Need help?
General
